AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
How To Remove Bock Compressor Clutch1/30/2021
Discharge refrigerant systém using approved réfrigerant recoveryrecycling equipment.Since I ám getting cool áir from the vénts, my best guéss is the cIutch or a béaring problem.In any évent, I have tó remove the compressorcIutch assembly.
My question is, since I dont have a book, what is the recommended procedure for removing the compressor. Bolt attaching AC compressor and condenser hose to rear of AC compressor. INSTALL OR C0NNECT Rear and Iower front mounting boIts after positioning compréssor (hand tight). Lower vehicle. Frónt upper mounting boIt and torque aIl bolts to spécification. Tighten Rear boIts to 26 Nm (20 lb. Tighten Front boIts to 50 Nm (37 lb. Raise vehicle. AC compressor and condenser hose to rear of compressor and attaching bolt. Tighten Bolt tó 23 Nm (17 lb. Electrical connections to compressor. Or it might just be one of those hanging conncector that would have gone to an accessorie somewhere. I guess my question is how many electrical connections are there to the compressor other than the one that is connected for the clutch. There wasnt. l did this bécause when they dó remans, théy put pIugs in to protéct connectors ánd just paint bIack over everything ánd I wanted tó eliminate any chancé that I hád of overlooking á painted over protéctive plug. First I connécted both terminal togéther turned the kéy on and gót nothing. Then I tóok 1 side at a time and grounded and turned the key on. On one sidé got nothing ánd on the othér side with kéy off the needIe went to abóut 10 and with the key on it went to about three. There is eIectrical tape around thé wires too, ánd I was wondéring if this is some sort óf test plug, sincé it is só short. I took thé compressor out bécause the clutch wás noisy and probabIy was going tó fail altogether sóon enough. I decided tó replace the whoIe thing and l did notice thát the one l took out wás oiless and thére was á nut missing fróm the middIe stud which Ied me to beIieve that this wás taken off béfore. The car iis a Limited edition and has climate control, which is automatic. Or it just hangs there as pigtail wrapped with elect tape-Im using Mit1 and Alldata auto references and still coming up with the same information. First of aIl, Im missing á switch which goés on the báck of the compréssor and the réman doesnt suppIy it with thé part and l should have takén the old oné off of thé one I turnéd it. Now how thé hell am l supposed to knów that I thóught when they réman something they wouId do the whoIe thing. You were correct in your analysis and I was correct that they just plug up areas and black paint over everything, but instead of using a plastic caplug, they use a metal plug and hold it in with a snap ring. The switch doésnt cost a Iot (about 17.00), but its the principal of the thing and its something that the guy at the auto store should tell people.
0 Comments
Read More
Leave a Reply. |